EV vs Gas Cost Calculator
Fuel is where EVs win their running-cost argument — by how much depends on your electricity price, the petrol price, and how efficient each car is. Enter both cars' real consumption figures and the prices you actually pay.
The results below are from your previous entries — fix the errors to update them.
You save per 100 miles (fuel only)
—
| EV cost per 100 miles | — |
|---|---|
| Petrol/gas cost per 100 miles | — |
| EV cost over the distance | — |
| Petrol/gas cost over the distance | — |
| Total saving over the distance | — |
Fuel and electricity only — not purchase price, insurance or maintenance.
How the calculation works
petrol cost per 100 miles = fuel used per 100 miles × pump price
Fuel used per 100 miles comes from your economy figure: 100 ÷ MPG gallons (US gallons in US mode; UK mode converts imperial gallons to litres, priced per litre), or L/100 km × 1.609 (100 miles expressed in km, priced per litre).
Worked example
An EV using 30 kWh per 100 miles at 0.1819 costs $5.46 per 100 miles. A 30 MPG (US) car at $3.50 a gallon burns 3.33 gallons and costs $11.67 — a saving of $6.21 per 100 miles, or $745.16 over 12,000 miles.
Assumptions and limitations
- Fuel and electricity only: purchase price, insurance, maintenance, tyres and depreciation are outside this comparison.
- Real-world economy differs from official ratings for both car types — use your own trip-computer figures where you can.
- Charging mostly on public rapid chargers narrows or erases the gap; the electricity rate you enter should match how you actually charge.
Walking through the calculation, step by step
The calculator on this page does one thing, and it does it in the open: it turns the numbers you type into the answer shown in the result table, using the formula above it. There is no hidden adjustment and no extra factor added after the formula. If you can follow the formula line by line, you can check the calculator by hand, and that is exactly what this section does. Start with the first field, ev electricity use, and read its help text before you type anything: the help tells you where the number comes from, and a number taken from the right place is the single biggest improvement you can make to the answer.
Here is the formula again, broken into its steps, in the order the calculator applies them:
- EV cost per 100 miles = consumption × electricity rate Work through this line before moving on: every number in it comes from a field above, so a wrong entry here follows you into the answer.
- petrol cost per 100 miles = fuel used per 100 miles × pump price Work through this line before moving on: every number in it comes from a field above, so a wrong entry here follows you into the answer.
Watch the units as you go, because most mistakes in this kind of calculation are unit mistakes, not arithmetic mistakes. The fields on this page use these units: economy, kWh/100 mi, miles/year, per unit. Power and energy are the pair that causes the most confusion: power, in watts or kilowatts, is a rate at which energy is used, and energy, in kilowatt-hours, is power multiplied by time. A 2,000 W heater running for one hour uses 2 kWh, and a 2 kW heater running for half an hour uses 1 kWh. Watts become kilowatts when you divide by 1,000, and kilowatt-hours are what your bill counts, so keeping those two apart is what makes the answer come out in the right size.
The worked example above is the best way to test whether you have understood the steps. It begins like this: An EV using 30 kWh per 100 miles at 0.1819 costs $5.46 per 100 miles. Read it slowly and match each number in it to a field above and to a line of the formula. Notice the order: the quantities are combined first, the rate is applied last, and the answer is then expressed for the period the example states. If you change one number in the example and keep the rest, the answer changes in the direction the formula predicts, and that is a useful habit: change one thing at a time, run the calculator again, and watch which output moves.
How to read your result
The result table on this page is a comparison, and its most useful figure is the difference between the two sides, not either side on its own. Each side is calculated with the same method and the same period, so the difference is a fair one: it is what changes if you switch from one option to the other and nothing else changes. Read the two sides first, then the difference, and then ask whether the difference is large enough to matter to you, because a small difference can easily be overturned by a price change or by a detail the calculator leaves out.
Read the result table row by row, in this order:
- EV cost per 100 miles is the row to read when you want that part of the answer on its own. Compare it with the headline row: if it is most of the total, it is the part to work on first, and if it is small, changing it will not move the answer much.
- Petrol/gas cost per 100 miles is the row to read when you want that part of the answer on its own. Compare it with the headline row: if it is most of the total, it is the part to work on first, and if it is small, changing it will not move the answer much.
- EV cost over the distance is the row to read when you want that part of the answer on its own. Compare it with the headline row: if it is most of the total, it is the part to work on first, and if it is small, changing it will not move the answer much.
- Petrol/gas cost over the distance is the row to read when you want that part of the answer on its own. Compare it with the headline row: if it is most of the total, it is the part to work on first, and if it is small, changing it will not move the answer much.
- Total saving over the distance is the row to read when you want that part of the answer on its own. Compare it with the headline row: if it is most of the total, it is the part to work on first, and if it is small, changing it will not move the answer much.
To judge whether your own answer is high or low, change only the rate and watch the result. The rates register on this site lists a United States national reference rate of 0.1819 per kWh, a Washington average of 0.1442, a Massachusetts average of 0.3019 and a Hawaii average of 0.4641. At those rates, 1,000 kWh costs $181.90, $144.20, $301.90 and $464.10. The same 1,000 kWh at the North Dakota average of 0.1246 costs $124.60, and the Montreal record in the register is 0.0829 per kWh, which gives 0.0829 times 1,000, or 82.90, for 1,000 kWh. The spread between those records is wider than most people expect, and it is why the rate matters as much as the amount you use: the same usage can cost roughly four times as much at the highest of those rates as at the lowest, and no change in how you use electricity can close a gap that comes from the price itself.
The worked example on this page puts the result in context. It ends with this conclusion: A 30 MPG (US) car at $3.50 a gallon burns 3.33 gallons and costs $11.67 — a saving of $6.21 per 100 miles, or $745.16 over 12,000 miles . Hold your own result next to that conclusion and ask whether the two are in the same range for similar inputs. If yours is far away, the most likely cause is an input that does not match the example, and the field help text above will tell you which one to check first.
What affects the result most
Not every input matters equally, and the ranking is written into the formula. An input that the formula multiplies by moves the answer in proportion: double it, and the answer doubles, as long as everything else stays the same. An input that the formula divides by moves the answer the other way: raise it, and the answer falls. A fixed charge is different again: it does not move at all when you use more, so it matters most when use is low and least when use is high. Before you spend effort improving an input, check where it sits in this ranking, because a precise number for a small input is worth less than a rough number for the biggest one.
- EV electricity use: raising this raises the result in proportion, because the formula multiplies by it. It is usually the input where a better measurement pays off first.
- Distance to compare: raising this raises the result in proportion, because the formula multiplies by it. It is usually the input where a better measurement pays off first.
- Fuel economy value: raising this raises the result in proportion, because the formula multiplies by it. It is usually the input where a better measurement pays off first.
- Fuel price: this scales the whole answer. A rate that is wrong by a tenth makes the answer wrong by a tenth, whatever else you enter, so it deserves the most careful reading of any field on the page.
- Standing charge: this adds the same amount every day, so it does not change when you use more energy. When use is low it can be a large share of the total, and when use is high it fades into the background.
A useful check is the doubling test. Take the worked example on this page, double its main quantity in your head, and ask what the formula would give: for a quantity the formula multiplies by, the answer doubles too. That is why the first thing to get right is the quantity itself — the amount used, the hours run, the area, or the distance — and the second thing is the rate or price. Everything else on the page is either a conversion between units, which the formula handles for you, or a fixed amount, which you can read straight from a bill.
Common mistakes
Most wrong answers from this calculator come from the same few slips. They are easy to make and easy to check for, and checking for them takes less time than re-doing the whole calculation:
- Using the wrong rate. A preset average is a starting point, not your tariff. If your bill shows a different rate, use that one: the calculator multiplies by the rate you enter, so a rate that is a few cents out moves the whole answer by the same proportion.
- Rounding too early. Rounding each step of a calculation before the next step uses the rounded number, and the rounding adds up. Enter the full numbers the calculator asks for, let it do the arithmetic, and round only the final answer when you quote it.
- Ignoring what the calculator leaves out. The assumptions section above lists what is not included in the answer — fixed charges, taxes, maintenance, installation and other costs, depending on the calculator. Treating the result as a complete bill, or as a complete saving, is the most common way to be disappointed by it afterwards.
- Trusting a nameplate figure for a cycling appliance. A fridge, an oven or an air conditioner does not draw its rated power all the time it is switched on: it cycles. Using the nameplate watts as if they applied continuously overstates the energy, and the assumptions section on this page says so for the appliances it applies to.
Making the comparison work for you
The result on this page is a starting point, not a verdict. These are the practical ways to use it:
- Use your own prices on both sides. A comparison built on preset prices is a comparison of averages. Put your own electricity price and your own fuel price in, and the difference becomes a number about your home and your car.
- Keep the period the same on both sides. The comparison only works if both options are costed over the same distance, the same year or the same charge. Change the period for one side and you must change it for the other, or the difference is meaningless.
- Remember what the comparison leaves out. The assumptions section above lists the costs this calculator does not include, and for a purchase decision those costs can matter more than the running-cost difference. Read them before you decide, not after.
- Re-run it when a price changes. Fuel and electricity prices move, and a comparison that was clear last year can be close this year. The calculation takes a minute, and re-running it with the new prices is the cheapest way to check whether the answer still holds.
Frequently asked questions
Why does the calculator ask for ev electricity use?
Because the formula needs it, and because it is the number most people get wrong. The help text next to the field says where the number comes from, and using the number from that source — a bill, a meter reading, a label, or a measured figure — is what makes the answer about your home rather than about an average one.
Can I use the preset rate, or should I use my own?
Use your own rate whenever you have it. The presets on this page are published averages or regulated figures, provided as starting points so the calculator works before you have a bill to hand. Your own rate, taken from a recent bill, is always the more accurate input, and the result moves in proportion to it.
Does the result include tax?
The calculator applies the rate you enter exactly as you enter it. If the rate you type already includes tax, the result includes it; if it does not, the result does not, and tax must be added afterwards. Where a calculator on this site has its own tax field, that field is the place to enter it, and the assumptions section above says which case applies to this page.
Which side wins if prices change?
The side that wins depends on the prices you enter, and prices change. Re-run the comparison with the new electricity price and the new fuel price, keeping the distance and the period the same, and the difference will tell you whether the answer still holds. A comparison is arithmetic, not a recommendation, and it is only as current as its prices.